FORD FDRS&FJDS Software with RLink X3 Lite Connection Instructions

FORD FDRS&FJDS Software with RLink X3 Lite Connection Instructions


FORD FDRS&FJDS Software with RLink X3 Lite Connection Instructions

Tips：You need to install the Ford OEM software before use. If it's not installed yet, you can download and install it from the official Ford website.

1.Open the RLink Platform.Clicking “Login to the Account” will automatically 

redirect you to the login page.Log in to the account bound to the RLink X3 Lite device.

Note: After binding and activating the device and downloading the driver, you can use the RLink X3 Lite device to perform vehicle diagnostics without opening the RLink Platform later.

2.Click the settings icon. Then click About to check whether there is an update for the RLink Platform. If yes,click Update.

3.Click Driver > Driver Download. Click FORD and click Download to download the driver.

Note: Download the corresponding driver according to the OEM software. Do not download drivers that are not related to the OEM software.






4.Click Driver > Driver Info. Then click FORD to configure the driver mode.


5.When using RLink X3 Lite devices, select RLink as the diagnostic interface on the OEM software. If you are connecting to the original VCI or third-party VCI, open the OEM software and select the original VCI or third-party VCI as the diagnostic interface. This driver will not have any impact. 

 

6.Double click the icon to open the FDRS.




7.After entering the Ford homepage, click the VCI icon in the lower right corner, select Other Device, then choose the Artidiag RLink mode in the selection box and click OK.

Note: If Artidiag RLink mode is unavailable, you may use TOPDON RLink or AA-RLink mode for programming and diagnostics.


8.After the VCI connects successfully, the indicator in the lower right corner will turn green. Log in to your FDRS diagnostic account to perform diagnostics and programming.



























Instructions for using FJDS in conjunction with RLink X3 Lite


  1. After the driver download is completed, open the FJDS for diagnosis.


2.Click the connection icon in the upper left corner, then click the tool icon in the lower left corner and select Select SAE J2534 pass-thru device. The J2534 selection box will pop up; choose TOPDON TECHNOLOGY Co.,Ltd.(04.04).


3.When the Select SAE J2534 pass-thru device window pops up, select RLink mode and click the checkmark to confirm.





4.Select the vehicle icon and click Start New Session. Keep clicking the checkmark to proceed to the next step.





5.Vehicle identification and diagnostics in progress.

If you encounter any problems, you can send an email to support@topdon.com.